Transmission drop spacer kit . Porsche 955 / 957 / 958 Cayenne

Porsche 958 Cayenne - 2010 to 2017

Product Description

Eurowise transmission drop spacers are designed to realign your driveshaft when lowering the subframe. We created these spacers specifically for the Gen 1 and Gen 2 Porsche Cayenne, Volkswagen Touareg, and Audi Q7 platforms after observing improved longevity of the input/output shaft seals on the driveshaft compared to vehicles without them. In some cases, they have also helped reduce drivetrain vibration on higher-mileage vehicles with worn driveshaft joints.

After 4+ years of research on hundreds of vehicles. We've seen front and rear driveshaft flex dust boots tear or separate from the subframe drop causing slight angle change from the drop. In some cases if your original boots were worn out it could be unavoidable. While the transmission spacer drop is not 100% required. Its advantageous to replace to keep driveline angles straight and extent the rubber boot life. This kit drops the transmission and center driveshaft support. Also included is a center support bracket to replace the original one from rubbing.

Select the thickness of the transmission drop bracket according to your subframe drop size. If you have a 1/2 inch subframe drop, you will not receive center support bearing drop spacers 

Product Includes: 
2 x Transmission drop spacers
1 x Tunnel brace
1 x Driveshaft support drop spacers
1 x Installation hardware

*only 1 pair per order*

0.5” Spacer Kit - For vehicles with .5" Subframe Drop 

1” Spacer Kit - For vehicles with 1” Subframe Drop 

1.5” Spacer Kit - For vehicles with 1.5” Subframe Drop 

Additional Options:
After over four years of research on hundreds of vehicles, we've found that front and rear driveshaft flex dust boots can tear or separate from the subframe drop, leading to slight angle changes. In some instances, worn-out original boots may make this unavoidable. While a transmission spacer drop isn't always necessary, it can help maintain proper driveline angles and extend the life of the rubber boots.

This kit includes a transmission and center driveshaft support drop, along with a center support bracket designed to replace the original one, preventing potential rubbing issues.

Choose the appropriate transmission drop bracket thickness based on your subframe drop size. Note: If you have a 1/2-inch subframe drop, center support bearing drop spacers will not be included.